User Guide

Applies to both ArcticBek 1 & 2

(Physical copy included for buyers)

Step 1: Set up

1. Unfold the water-cooled, superconducting bed topper completely flat on your bed.

2. Place the ArcticBek on a flat, stable surface.

Important: must be positioned higher than the mattress to ensure proper water circulation.

Step 2: Connection

1. Locate the silicone connection tubes. Connect one end to the mattress and the other end to the inlet/outlet connectors on the host machine.

2. Ensure the tubes are firmly inserted to prevent any water leakage.

Step 3: Filling the Tank

1. Open the water inlet on the ArcticBek 1 & 2. Pour in approximately 1400ml(1)/2000ml(2) of clean tap water or purified water.

(Use ice/cold water to enhance cooling effect)

2. Ensure you do not overfill initially, but have enough water to prime the system.

Step 4: Power On & Circulation

1. Plug the power adapter into an outlet and connect it to the ArcticBek. Press the power button to start the machine.

2. Prime the Mattress: Because the mattress is initially empty, water from the tank will immediately begin flowing into it.

3. Refill: As water flows into the mattress, the tank level will drop. Continuously add water to the tank until the water level stabilizes at the "Max" line. Once full, the system will operate normally.

Step 5: Operation & Settings

1. Fan Speed (ArcticBek 1) & Temperature level

(ArcticBek 2) : Use the remote control or unit buttons to adjust the wind speed/ temperature.

ArcticBek 2 features:

12°C - 55°C

ArcticBek 1 features:

• First Gear: Soft wind

• Second Gear: Comfortable wind

• Third Gear: Strong wind

• You can use the independent cooling fan function if desired.